Results 1 to 4 of 4

Thread: home network and ifplugd

  1. 12-11-2003, 12:31 PM #1
    bobblebob
    bobblebob is offline
    Associate
    Join Date
    Apr 2003
    Posts
    43

    home network and ifplugd

    Hello
    I have just installed Mandrake 9.2 on a friends computer. All works fine but I can't get the network to start at boot time. I can start it manually once logged in. The network modal is set to be initiated at startup but I get the following error ' Sorry there is already an instance of ifplugd enabled for eth0'. What is ifplugd? what's initializing it? any Ideas?
    Darren
    Reply With Quote Reply With Quote
  2. 12-11-2003, 03:59 PM #2
    pbharris
    pbharris is offline
    Good Guru pbharris's Avatar
    Join Date
    May 2001
    Posts
    4,424

    Re:home network and ifplugd

    looks like it is a tool to setup interfaces more automatically then an ifup command. - i would dump it it unless ya need it.
    http://freshmeat.net/projects/ifplug...p;topic_id=150
    Reply With Quote Reply With Quote
  3. 12-11-2003, 07:39 PM #3
    bobblebob
    bobblebob is offline
    Associate
    Join Date
    Apr 2003
    Posts
    43

    Re:home network and ifplugd

    hello
    I'm not to sure where it is. I thought it would be in one of the rc#.d folders but it's not. Any idears?
    Reply With Quote Reply With Quote
  4. 12-11-2003, 11:37 PM #4
    pbharris
    pbharris is offline
    Good Guru pbharris's Avatar
    Join Date
    May 2001
    Posts
    4,424

    Re:home network and ifplugd

    i would try rpm -e ifplugd to remove it. it may be started by xinetd
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules