I was trying to set up Grub. I downloaded the source for 0.91, applied the boot splash patch, and installed it. It went flawlessly. Then I went to the PET's page to look up the GRUB pet. I realize that it says there that, after installing Grub, I should have a /boot/grub directory. But no directory appeared.
I haven't tried to run grub yet, since I don't know how it will work without this folder. There seems to be no menu.lst or grub.conf either. Any ideas?
This is my lilo.conf:

# LILO configuration file
append="hdc=ide-scsi"
boot = /dev/hda
message = /boot/boot_message.txt
prompt
timeout = 1200
change-rules
reset
# VESA framebuffer console @ 1024x768x256
vga = 773
# DOS bootable partition config begins
other = /dev/hda1
label = Windows
table = /dev/hda
# DOS bootable partition config ends
# Linux bootable partition config begins
image = /boot/vmlinuz
root = /dev/hda4
label = Linux
read-only
# Linux bootable partition config ends
# Linux bootable partition config begins
image = /boot/vmlinuz-2.4.20pre5
root = /dev/hda4
label = Slackware
read-only
# Linux bootable partition config ends