bios password

[Compunuts]

If you have read the link REX had given, you will read the following.....

JP4: CMOS Function Select:

Open: Normal setting Closed: Clear CMOS setting

This is the place where you need to reset the jumper. No need to take out the battery.....

[TaeShadow]

If you still can't find it, just pull out all the jumpers and put them back in.

[agar]

even if the board is just sitting there not hooked up. I just pull it completly out and back in?

[popcorn]

In a word, yes.

[Schotty]

Here, look on the board for JP4 and pull it off the one pine it is hooked up to and connect both pins for about 5-10 seconds. Pull it off and dangle it on just one pin. You should be at the BIOS defaults (no passwword)

[CP]

You have to turn the PC on while JP4 is connected, not just switch it on and leave it off. But there has to be a battery. There just has to.