Add a network card

[benny666]

I have a 100tx link sys network card
I saw it is competible with red hat 7.0

But still the system doesn't recognize it.

They say to add kernel module
2.2.16-22 stock kernel
how do I do that??

Or how do I use my link sys cd to upload the driver of the card??

[ph34r]

Do your docs say what kernel module it uses? If so, then you simply need to insmod or modprobe that module, and then configure your card.

Remember - eth0 and eth1 will be determined by which card is initialized first, unless you are specifically aliasing one of them in modules.conf

[pbharris]

hi benny,
this is good for netconf - select eth0 and the pick out the module, it should be very straight forward.